Page 3 of 3

Re: unknown enum error after finish

PostPosted: Thu Jun 25, 2020 3:42 pm
by mwroggenbuck
Hello Again,

Well, I am definitely on to something. Since I stared running the core process with the priority and affinity change, I have only had one failure. That was also in the AMD driver, not the ntdll.dll.

Again, I don't want any user to change their setup based on what I have written here, but I hope it helps the code maintainers.

Please send me a PM is you want more information. I'd be happy to answer any questions about what I have done.

Re: unknown enum error after finish

PostPosted: Fri Jun 26, 2020 2:34 pm
by mwroggenbuck
Well, I just had an error after 100%, but it was an access violation, not an unknown enum. The client was able to send the "bad" work unit back to the system, so I guess I am making progress. :D

In any event, I am still doing much better than before. I just wish I knew why I seem to be the only one with this enum error after the job reaches 100% I will keep investigating if I think of anything else.

Re: unknown enum error after finish

PostPosted: Fri Jun 26, 2020 3:33 pm
by Joe_H
There is another report of this after finish, in the case about 90 minutes after. That topic is here - viewtopic.php?f=19&t=35658, have not compared it to your error to see if it is exactly the same. Developer is aware of both topics and looking into this.

Re: unknown enum error after finish

PostPosted: Fri Jun 26, 2020 3:58 pm
by mwroggenbuck
If you need me to do anything to help debug, just let me know via PM. I will be glad to help if I can.

Re: unknown enum error after finish

PostPosted: Fri Jun 26, 2020 7:09 pm
by Joe_H
JohnChodera in that other topic has asked for some debugging help.

Re: unknown enum error after finish

PostPosted: Sat Jun 27, 2020 12:50 pm
by mwroggenbuck
Hello all,

Well, I spoke too soon. In the last 24 hours, I have had 8 failures.

I will put more information (and all future communication) at the following link:

viewtopic.php?f=19&t=35658